UDO Super 6 — Owner’s Manual
95
The following table lists the additional modulation destinations available to
you when using direct parameter control mappings:
Modulation Destination
Modulation Destination
1
DDS 2 Tune
12
Envelope 1 Release
2
Oscillator Mix
13
Envelope 2 Attack
3
VCF Cutoff Frequency
14
Envelope 2 Decay
4
VCF Envelope Amount
15
Envelope 2 Sustain
5
VCF LFO 1 Amount
16
LFO 1 Delay
6
VCF DDS 2 Amount
17
LFO 2 Rate
7
VCA Envelope Level
18
LFO 2 Delay
8
VCA LFO 1 Amount
19
DDS Modulator LFO 1 Amount
9
Envelope 1 Hold
20
DDS 2 Pulse Width / DDS 1 Detune
10
Envelope 1 Attack
21
Portamento Time
11
Envelope 1 Sustain
22
Delay Level
Clearing Modulation Mappings
If you would like to clear all mapped modulation, press the
SHIFT
button and then the
MOD ASSIGN
button. All modulation routing will
be instantly erased.
To clear modulation per source or per destination, follow the steps below:
1. Press the
MOD ASSIGN button. Its LED will flash, indicating that
you have entered modulation assign mode.
2.
If you would like to clear all modulation only mapped from a specific
source, including direct parameter control modulation, press the
source button (patch select button
1
-
8
) corresponding to the source
for which you wish to remove mapping. Then, press the
SHIFT
button and then the
MOD ASSIGN
button. All modulation mapped
from the selected source only will be instantly erased.
3.
If you would like to clear all modulation only mapped to a specific
destination contained within the available modulation destinations
in the modulation matrix, press the destination button (bank select
button
A
-
H
) corresponding to the destination for which you wish to
remove mapping. Then, press the
SHIFT
button and then the
MOD
ASSIGN
button. All modulation mapped to the selected destination
only will be instantly erased.
Summary of Contents for SUPER 6
Page 142: ......