EN-51
Operating the unit
What should you do if cyclotest® baby was not to hand on the first day
of menstruation or you forgot to make the input?
Press the small round Cycle Start button again firmly and for a sus-
tained period. At the same time press the right Arrow button repeat-
edly until your current cycle day appears in the display (e.g. DAY NEW
02). Keep the Start button pressed until the input is confirmed with a
beep. Your display should now look like this:
Fig. no. 3
Important:
After a new cycle start you can no longer print out the last
fertility profile.
How to measure your wake-up temperature
Once the cycle start has been successfully input, you can take your
temperature measurements. Begin the morning after before getting
up.
Note:
At least 5 hours sleep needed prior to measurement. The meas-
urement must be taken before you get up.
The sensor is located at the top in the sensor compartment. Pull the
round cable reel on the back of the unit to extend the length of the
cable sensor as required by uncoiling. This enables you to take your
measurement comfortably while lying down. Then close the reel
again.
Summary of Contents for cyclotest baby
Page 6: ...DE 6 Bedienung des Gerätes Gerätebeschreibung 1 2 3 4 5 6 7 8 ...
Page 48: ...EN 48 Operating the unit Unit description 1 2 3 4 5 6 7 8 ...
Page 90: ...FR 90 Utilisation de l appareil Description de l appareil 1 2 3 4 5 6 7 8 ...
Page 132: ...IT 132 Uso dell apparecchio Descrizione dell apparecchio 1 2 3 4 5 6 7 8 ...
