Installing the handlebars
Undo the screw (1) at the top and remove the black
protective cap (2) of the handlebars support (ballhead
tube).
Put on the preassembled handlebars, as shown on
WKH¿JXUHDQGVWUDLJKWHQWKHP:KHQSXWWLQJRQWKH
handlebars, watch out for the cable and cable guide.
Tighten the screw (1) lightly.
After aligning the handlebars, tighten the screws (3) (one
screw each on left and right) alternately with approx. 6 Nm.
Installing the saddle
Open the quick-release lever (1) and insert the seat post
with saddle (C).
Adjust the saddle to the required height, turn the quick-
release lever (1) and fold it in until the saddle sits tight.
Caution
6KRUWFLUFXLWDQG¿UHULVN
Never set the saddle lower than the “12” mark, as
otherwise the saddle bar can hit the fastener of the
battery charger socket while the moped is in use and
damage the charge connection.
Caution
5LVNRILQMXU\
Only move the saddle upwards so that the seat post is
still completely in the seat post retainer (1) provided.
Mounting the rear-view mirror
Screw the threaded bar of the rear-view mirror (B) into
the threaded opening (1) provided on the left-hand side
of handlebars, until the mirror sits securely in the required
position.
Then tighten (lock) the nut (2) on the threaded rod using a
suitable tool.
Installing the saddle
000
0007 A
1
3
3
2
000
0009 A
B
1
2
000
0008 A
12
1
C
28
Ī
Ī
