Auto On/Auto power off (APO)
• Press any button to power on meter.
• Press and hold
AC/DC Volts/Power
button to power off meter.
• Auto power off (Apo) after 10 minutes of inactivity.
(5 minutes in resistance mode)
• Press and hold the AHold button when meter is in Hold mode to disable Auto
power off mode. Press and hold again to enable Auto power off mode.
CAT IV
600V
VΩ
DL220
A-HOLD
LRA INRUSH
Resistance: <2000Ω
Features:
A-HOLD
LRA INRUSH
WARNING
• Do not measure resistance on a live circuit.
Resistance
Ranges
Resolution
Accuracy
Overload Protection
200Ω to 2000Ω
0.1Ω to 1Ω
±(0.8% + 4 dgts)
600V
Max displayed value: 2200Ω
Overload protection: 600V AC RMS or 600V DC
• Default =
• Press x1 =
• Press x2 =
CAT IV
600V
VΩ
DL220
A-HOLD
LRA INRUSH
CAT IV
600V
VΩ
DL220
A-HOLD
LRA INRUSH
AC/DC Voltage: <600V AC/DC
WARNING
•
Do not attempt to measure more than 600V AC/DC.
•
Keep hands below line when measuring high current levels.
• Do not exceed 600V DC or AC-RMS on either the common or
multifunction test leads as measured from earth ground.
Select AC or DC Voltage.
Features:
A-HOLD
LRA INRUSH
AC Volts
Ranges
Resolution
Accuracy
Overload Protection
1V to 199.9V
0.1V
±(1.5% + 5 dgts)
600V
200V to 600V
1V
DC Volts
Ranges
Resolution
Accuracy
Overload Protection
1V to 19.9V
0.01V
±(1.5% + 3 dgts)
600V
20V to 199.9V
0.1V
200V to 600V
1V
Minimum measurement AC mV: 500mV/DC mV:40mV
Response time (input; AC 100V): 1 sec
Max displayed value: 660V AC/DC
High warning symbol input voltage > AC30V/ > DC30V
Meter beeps input voltage > AC 601V/ > DC 601V
Input impedance: 10MΩ
Frequency Range: sine wave: 45Hz to 400Hz
Overload protection: 600V AC RMS or 600V DC
• Default =
• Press x1 =
• Press x2 =
• Default =
• Press x1 =
• Press x2 =
www.
.com
information@itm.com
1.800.561.8187
