• Default =
• Press x1 =
• Press x2 =
Continuity
• Buzzer sounds at less than 40Ω.
WARNING
• Do not measure resistance on a live circuit.
Features:
A-HOLD
LRA INRUSH
Continuity
Audible threshold
Response time
Overload Protection
Approx : < 40Ω
50ms
600V
CAT IV
600V
VΩ
DL220
A-HOLD
LRA INRUSH
AC Amps: <200A
• Center wire in conductor alignment marks for best accuracy.
• Opposing currents cancel
(use line-splitter when necessary).
WARNING
• Keep hands below guard when measuring high current levels.
• Do not attempt to measure more than 200A AC.
Features:
A-HOLD
LRA INRUSH
AC Amps
Ranges
Resolution
Accuracy
Overload Protection
1A to 200A
0.1A
±(2.0% + 5 dgts)
600V
Frequency Range: sine wave: 45Hz to 400Hz
Maximum Displayed value: AC220A
Minimum Displayed value: AC 500mA
CAT IV
600V
VΩ
DL220
CAT IV
600V
VΩ
DL220
A-HOLD
LRA INRUSH
Single
Conductor
Only
LRA Inrush
• The meter must be in AC Amps mode first to be placed into LRA
measurement mode.
• The UEi LRA Inrush is programmed to properly capture the starting current
for compressor motors.
• Press and hold
A-Hold/LRA Inrush
button – INRUSH will now be shown on
the display.
• Activate compressor and read value on display.
• Press and hold
A-Hold/LRA Inrush
button to return to live readings.
• Press x1 =
A-HOLD
• Press again to power
off A-Hold
• Press and hold =
LRA INRUSH
• Press and hold again
to power off LRA Inrush
A-HOLD
LRA INRUSH
CAT IV
600V
VΩ
DL220
CAT IV
600V
VΩ
DL220
A-HOLD
LRA INRUSH
Single
Conductor
Only
www.
.com
information@itm.com
1.800.561.8187
