130
installation method of the robotic arm and the payload setting of
the robotic arm are consistent with the actual situation, otherwise
it will be dangerous.
2. The serial number of robotic arm and the control box need to be
matched before Manual Mode can be turned on. The SN of the
control box can be checked in 【Settings】-【My Device】-
【Device Info】.
3. The SN address of the robotic arm can be checked next to the power
signal interface of the base.
1.5.4 Recording
The position of the joint is obtained and recorded by 250HZ to record the
motion trajectory of the robotic arm in free driving, and the maximum
recording time is 5 minutes. The playback will completely repeat the
Summary of Contents for 850
