14
whatsoever for any loss, destruction, or damage arising from or in
respect of any use or misuse of 850.
●
Validity and Responsibility
The information does not cover how to design, install, and operate a
complete robotic arm application, nor does it cover all peripheral
equipment that can influence the safety of the complete system. The
complete system must be designed and installed under the safety
requirements outlined in the standards and regulations of the country
where the robotic arm installed.
The integrators of the 850 are responsible for the compliance of
applicable safety laws and regulations in the country, to prevent any
hazards in the operating environment.
Safety precautions include but are not limited to:
●
Making a risk assessment for the complete system. Make sure to
have a safe distance between people and 850 when interacting with
the 850.
●
Interfacing other machines and additional safety devices if defined
by the risk assessment.
●
For software programming, please read the interface
documentations carefully and set up the appropriate safety
Summary of Contents for 850
