35
the orientation of the end-effector must be
archived as a file.
3.
Make sure that the tool is safely constructed such
that it cannot create a hazardous situation by
dropping a part unexpectedly.
4.
Pay attention to the operation specifications of
sharp end-effector tools.
5.
If the installed end-effector exceeds the robotic
arm mounting surface at the zero position of the
robotic arm, a safety assessment is required for the
zero return operation.
1.3.
Power Supply for the Robotic Arm
1.3.1.
Preparation before Power On
•
Ensure the power cable and the communication wire are properly
connected between the Control Box and the robotic arm.
•
Ensure the network cable or RS-485 cable is properly connected.
•
Ensure the power cable for the Control Box is properly connected.
•
Ensure the xArm will not hit any personnel or equipment within
the working range.
