7
WE WOULD LIKE TO THANKS YOU FOR CHOOSING UFESA,
WE WISH THE PRODUCT PERFORMS TO YOUR SATISFACTION AND PLEASURE.
WARNING
PLEASE READ THE INSTRUCTIONS FOR USE CAREFULLY PRIOR TO USING THE PRODUCT. STORE
THESE IN A SAFE PLACE FOR FUTURE REFERENCE.
DESCRIPTION
1. Motor unit*
2. Telescopic tube
3. “Y” foothold
4. Water fender*
5. Telescopic rod
6. Nylon trousers balloon
7. Mounting flange*
8. Adjustable timer (30/60/90/120/150/180 minutes)*
*SV1200 ready2go Ufesa garment steamer is required. Pants accessory is valid for this model.
ASSEMBLY
1. Firstly, be sure SV1200 Ufesa garment steamer is completely disassembled. Please, keep one
telescope tube (2) from it.
2. Pull out both telescope tubes (2) by rotating anti-clockwise and assembly them in the “Y” foo-
thold (3).
3. Assemble the water fender (4) on the small tube and tighten the screws to the indicated height.
4. Plug the telescopic rod (5) into the recess on the top of the motor unit (1).
5. Attach the nylon trousers balloon (6).
6. Pull the large elastic cord at the bottom over the mounting flange (7). The nylon balloon should
sit immediately below the mounting flange so that it can fully inflate.
6. Put on the trousers.
8. The device is disassembled in the reverse order.
CAUTION: Only place the device on a stable, flat, moisture-resistant and heat-resistant surface.
Caution! Hot surface!
The motor unit / telescopic rod will become hot during use. You should
therefore not touch it during or shortly after use.
It is essential that you follow the care labels for the textiles to be dried!
E N G L I S H
