36
EN
9. Only wipe the main appliance with a damp soft cloth!
10. If the bowl and blade is hard to clean. You may add some hot soapy water in the bowl and run the
appliance at speed 1 for few seconds.
11. When there is burn mark on blender jug bottom, put some citric acid or lemons into water, heat 5
minutes, and then remove the burn mark with a mop.
FAULT CODES
Code
Status
Solution
E1
“E1” shows on LCD, and sound
“Beep” will be heard.
Motor overload. Un-plug, cool down the device for
an hour. Afterwards, it is ready for use again.
E2
“E2” shows on LCD, and sound
“Beep” will be heard.
No weighing sensor was detected or the weighing
sensor is damaged
.
E3
“E3” shows on LCD, and sound
“Beep” will be heard.
The bowl wasn’t installed. Install it according to
the operating instruction or NTC is damaged.
E5
“E5” shows on LCD, and sound
“Beep” will be heard
There’s no water for steamer function. Add water
to rework.
End
“End” shows on LCD, and sound
“Beep” will be heard
Program end. Press knob and return standby
mode.
RESET TEMPERATURE CONTROL
If the temperature gets over and the jug does not work, please, press the temperature button to reset
temperature control. After cooling the jug, it can work as normally.
PRODUCT DISPOSAL
This product complies with European Directive 2012/19/EU on electrical and electronic
devices, known as WEEE (Waste Electrical and Electronic Equipment), provides the legal
framework applicable in the European Union for the disposal and reuse of waste electronic
and electrical devices. Do not dispose of this product in the bin, instead going to the electrical
and electronic waste collection center closest to your home.
Temperature button.
Press it and “Click”
Summary of Contents for TotalChef RK3
