UFESA Vancouver, Instruction Manual

13

- sources of heat (e.g. open flames, gas ovens, etc.)
- deposits of liquids (e.g. sinks, etc.) to avoid falling into or splashing with water (minimum 

distance 2 metres)
- fabrics (curtains, etc.) or loose materials, which may obstruct the ventilation grille; in 

addition, check that the front part is free of volatile materials (dust, etc.).
• The supporting surface must be stable, flat and even (so that the appliance does not tip 

over). 

ASSEMBLY

Warning: 

 the fan may be used only if it is fully and properly assembled, that is to say, com-

plete with the base and the grille.

Warning:

 always disconnect the appliance from the mains supply before assembling. if in 

doubt, have the operation checked or carried out by a qualified technician. 

ASSEMBLY FF1450 MODEL

1. Place it on the round base face down and attach it with the plate to fix the base, place the 

washer and screw it together with the adjustable rod so that the base and rod are fixed (7). 
2. Take the main body of the fan, place it on the fan bracket (9) and fix it in place with the 

screws so that it is firmly attached and then secure the adjustable “T” shaped rod with the 

screws.

USE

Before each use check that the appliance is in good condition and that the electric cable 

is not damaged; if the electric cable is damaged, it must be replaced by the manufacturer 

or by the technical assistance service or, in the event, by a qualified technician, in order to 

avoid any type of danger. 
Insert the plug into the mains socket.

Ventilation: 

 Select the required speed by pressing the speed selector using the following 

positions: 1 - Minimum speed 2 - Medium speed 3 - Maximum speed
To turn the fan off, turn the selector to the “0” position and then remove the plug from the 

mains socket.

Vertical inclination (high-low): 

this is adjusted by holding the motor body and tilting it in 

the desired direction.

During long periods of inactivity, disconnect the plug from the mains socket.

CLEANING AND MAINTENANCE

Warning: 

before carrying out the normal cleaning operations, remove the plug from the 

mains socket.
• To clean the appliance, use a soft, slightly damp cloth; do not use abrasive or corrosive 

products.
• Do not immerse any part of the fan in water or any other liquid: if this happens, do not 

immerse your hand in the liquid and, first of all, remove the plug from the mains socket.  

Carefully dry the device and check that all the electrical parts are dry as well: if in doubt, 

contact a qualified technician.