S9500-30XS Hardware Installation Guide | 18
10
Verifying System Operation
Front Panel LED
Verify basic operations by checking the system LEDs located on the front panel. When operating
normally, the PWR, FAN, and STAT LEDs should all display green.
Figure 26.
LED Condition
Equipment Status
GNSS
Off
GNSS is not configured.
NOTE: Need NOS to activate this feature.
Solid Green
GNSS is in normal state. Self-survey is complete.
NOTE: Need NOS to activate this feature.
Blinking Green
GNSS is in learning state. Self-survey is not completed.
NOTE: Need NOS to activate this feature.
Solid Yellow
Power up. GNSS is not tracking any satellite.
Blinking Yellow
GNSS antenna is short to ground.
NOTE: Need NOS to activate this feature.
SYNC
Off
System timing synchronization is disabled or in free-run mode.
**Note: need NOS to activate this feature
Solid Green
System timing core (1588 and SyncE) is synchronized to external
timing source (ex: GNSS, 1PPS, PTP, BITS, etc.)
**Note: need NOS to activate this feature
Blinking Green
System is synchronized in SyncE mode.
**Note: need NOS to activate this feature
Solid Yellow
System timing core is in acquiring state or holdover mode.
Blinking Yellow
System timing synchronization fail.
**Note: need NOS to activate this feature
STAT
Off
System (X86 & BMC) no boot
Solid Green
System boot complete
**Note: need NOS to activate this feature
Blinking Green
System is booting
