S9501-18SMT
Hardware Installation Guide | 24
12.
4
Connecting the 1PPS Interface
Connect an external 1PPS
cable
with an impedance of 50 ohms to the port labelled
“ 1PPS”.
12.
5
Connecting the 10MHz Interface
Connect an external 10MHz
cable
with an impedance of 50 ohms to the port labelled
"
10MHz”.
12.
6
Connecting the Transceiver
Note
To prevent over tightening and damaging the optic fibers, it is not recommended to
use tie wraps with optical cables.
Read the following guidelines before connecting the transceiver:
•
Before installing the router, take into consideration rack space requirements for cable
management and plan accordingly.
•
It is recommended to use hook-and-loop style straps to secure and organize the cables.
•
For easier management, label each fiber-optic cable and record its respective connection.
•
Maintain a clear line of sight to the port LEDs by routing the cables away from the LEDs.
Caution
Before connecting anything (cables, transceivers, etc.) to the router, please ensure to
dischage any static electricity that may have built up during handling. It is also recommended
the cabling be done by a professional who is grounded, such as by wearing an ESD wrist strap.
1.
Remove the new transceiver from its protective packaging.
2.
Remove the protective plug from the transceiver port.
3.
Place the bail (wire handle) in the unlocked position and align the transceiver with the
port.
4. Slide the transceiver into the port and use gentle pressure to secure it in place. An
audible click can be heard when the transceiver is secured in the port.
Please follow the steps below for connecting a transceiver.
