Uflex A95, Installation And Maintenance Manual

TIE BAR A95

-  

page 11 

of 19

Installation and Maintenance Manual 

5  Using a 22 mm wrench act on one of the end 

elements (6) or (7) and carry out the fine adjust-

ment of the bar length.

6  Once the fine adjustment has been carried out, tighten the 

ring nut (8) using a 22 mm wrench with a tightening torque 

of 40 [Nm] (29.52 [lb ∙ ft]) by means of a second wrench on 

the end element ( 7).

If during the use of the boat it is necessary to vary the distance between centers of the engines (i.e. the angle of 

divergence or convergence), proceed as follows.

WARNING

Before carrying out the following operations, it is mandatory to turn off the engines and operate in safe conditions.

WARNING

Check if the engine can also tilt independently and in different 

steering positions.

CAUTION

In no event shall the bar and/or its connections constitute a 

limitation to the steering allowed by the installed steering 

system and to the lifting of the engines. 

2.3 Adjustment of the distance between centers with installed bar

1  Loosen the ring nut (1) by means of a 22 mm 

wrench holding it still with a second wrench on the 

end element (2).

6

7

8

1

7

2