I. Assembling the Stand Fan Body to the Base
1. Take out the stand pole, stand round base and base nut.
2. Match and fix the stand pole to stand round base.
3. Use the base nut to screw the body and round base together tightly.
II. Assembling the Rear Guard
1. Take out the blade cap from the shaft turning it clockwise.
2. Take out the rear guard mounting nut turning it anti-clockwise.
3. Insert the rear guard into the motor matching 3 rods on the front side of the
motor (the handle will direct upwards) to 3 holes of the rear guard.
4. Fasten the rear guard tightly by turning the guard mounting nut clockwise.
III. Assembling the Fan Blade
1. Insert the blade to the shaft and ensure the pin enter the blade slot.
2. Tighten the blade using the blade cap turning anti-clockwise in the direction
"
TIGHT
" arrow on it.
Note: Proper assembly of the blade is of great importance. Otherwise, the blade
spins in the air and damage the appliance.
IV. Assembling the Front Guard
1. Fix the front guard with the logo in the upright position on the rear guard. Make
sure that they are connected from the upper side.
2. Take the front guard rim to set in groove and fix it with screwdriver.
Note: Do not operate the fan without assembling the guards properly and tightly.
Assembly of the Fan
4
4
