OPERATION
7
UFO
LIGHTING
USING
THE
LIGHT
SOURCE
-
LUNA
M
MODELS
ONLY
Under normal operation the LUNA M light source can be dimmed manually using the dimmer
control on the rear of the unit.
USING
THE
LIGHT
SOURCE
-
LUNA
DMX
MODELS
ONLY
The DMX light sources can be dimmed remotely (single channel 0-255 – see table below) and can
be addressed manually.
Single Channel Value
0
255
Descrip
ti
on
LED
o
ff
LED
brightest
Unless the address is specified on the purchase order, all light sources will be defaulted to
address 001. Connect the DMX controller to either of the Mini XLR sockets, and the light source
can now be dimmed. Additional slave (which are set to the same address) DMX light sources can
be linked together.
1. Disconnect the light source from the mains supply.
2. Tilt the light source on its side and remove the screw from the base as shown below.
3. Slide the access cover down to remove and set the cover and screw aside.
4. Switch DIP switch 10 (top) to ON as shown below.
5. Replace access cover and securing screw.
REVERTING
A
DMX
LIGHT
SOURCE
TO
MANUAL
OPERATION
MODE
Summary of Contents for LUNA SLP-3000M
Page 15: ...NOTES 15 UFO LIGHTING...
