REMOTE
CONTROL
OPERATION
No.
Descrip
ti
on
Func
ti
on
1
Bu
tt
on
Power on
2
Bu
tt
on
Power o
ff
3
Color Ring
Touch control all colors (white not available)
4
Indicator
Indicates controller ac
ti
ve when bu
tt
ons pressed
5
Bu
tt
on
Increase color cycle speed
6
Bu
tt
on
Increase brightness
7
Bu
tt
on
Decrease brightness
8
Bu
tt
on
Decrease color cycle speed
9
Bu
tt
on
[Mode +] Step up through color cycle programmes
10
Bu
tt
on
[Mode
] Step down through color cycle programmes
10
9
8
7
6
5
4
3
2
1
MATCHING
REMOTE
CONTROL
UNIT
TO
ILLUMINATOR
Remove the power plug from the rear of the illuminator, then
replace and touch button 5 within 3 seconds, the illuminator
will “blink” twice slowly indicating that the Remote Controller
is matched to the illuminator.
Once the remote is matched, follow the procedure on page 10
to put the illuminator into remote programme mode. The illu-
minator should then respond to remote commands.
UNMATCHING
REMOTE
CONTROL
UNIT
FROM
ILLUMINATOR
Remove the power plug from the rear of the illuminator, then
replace and touch and hold button 5 within 3 seconds and the
illuminator will “blink” 9 times indicating that the Remote Con-
troller is unmatched from the illuminator.
OPERATION
7
UFO
LIGHTING
Note:
More than one illuminator controlled by one Remote
Controller will eventually run out of sync with each other (color
cycle mismatch)
