UFO Vega CM, Product User Manual

Thank you for purchasing this UFO light source. 
 
To ensure that the light source is set up optimally and gives a long service life, please read this 
user guide before installing, operating or performing any maintenance on the unit. 
 
Please keep this user guide for future reference. 
 
This light source is suitable for indoor use only unless it is situated in a weatherproof enclosure.

MODELS

COVERED

BY

THIS

USER

GUIDE

UFO Vega CM / UFO Vega TM 
UFO Vega MCM / UFO Vega MTM 
UFO Vega CDMX / UFO Vega TDMX 
UFO Vega C 0-10V / UFO Vega T 0-10V 

IMPORTANT

This product must be installed in accordance with the applicable installation code, by a person 
familiar with the construction and operation of the product, and the hazards involved. 
 
These light sources are not mains dimmable. 
 
The LED array and heatsink in this light source can be replaced when it reaches end of life. 
Contact UFO for details.  
 

Type Y Attachment: 

If the external flexible cable or cord of this luminaire or associated 

PSU/driver is damaged, it shall be exclusively replaced by the manufacturer or his service agent 
or a similar qualified person to avoid a hazard. 
 

Location: 

Do not locate this light source closer than 200mm from any flammable surface. 

Clearance / Ventilation: 

It is imperative that a gap of 200mm is left around the unit. This is to 

allow air to circulate and prevent overheating. The location must have free ventilation and must 
not have an ambient temperature higher than that specified for the luminaire. 
 

Mounting: 

 This is a fixed luminaire. See mounting plate instruction on Page 3 for 

fixing to surface. 
 

Warning: 

Never look directly into the luminaire LED light source. 

Warning: 

The luminaire should be positioned so that prolonged staring into the 

luminaire at a distance closer than 0.33m is not expected.

INTRODUCTION

VEGA

USER

GUIDE

2