UFO Vega CM, Product User Manual

The 0-10V control type needed in the Vega light source is current source, not current sink. The 
unit relies on the control unit to supply the 0-10V control voltage. 
 
There are three connections required - the fibre port, the mains supply cable and the 0-10V 
control cable. The fibre port should be connected first. Connect and secure the fibre optic 
connector into the collar and secure using the M5 locking screw. 
 
Connect the PSU to the DC input jack socket on the light source, and connect the IEC plug to the 
PSU. Plug the mains plug into the electrical supply socket. Switch on power – the red LED 
Indicator will illuminate and the light source is ready for use. If no light is produced consult the 
TROUBLESHOOTING section of this user guide. 
 
THE LIGHT SOURCE WILL NOT ILLUMINATE UNLESS DIP SWITCH 10 IS ON AND A 0-10V 
SIGNAL IS PRESENT 
 
Connect the 0-10V control cable(s) to the Mini-XLR socket(s) on the rear of the light source. The 
recommended plugs for these sockets are Multicomp SVP556-TA (female) or Multicomp SVP555-
TA (male). The pin out details for these plugs are shown below.  
Either socket may be used as 0-10V IN or 0-10V OUT 

CONNECTION

 - 

VEGA

C

0-10

V

AND

T

0-10

V

MODELS

ONLY

Note: 

UFO can supply converters for these light sources to allow them to be interfaced to 

standard 3 pin XLR connectors or RJ45 connectors. 

INSTALLATION

5

UFO

LIGHTING