NOTES
ON
POWERING
UP
THE
VEGA
CDMX
LIGHT
SOURCE
1. If internal DIP switch 10 is OFF, the wheel will find its reference point and stop on colour 1
(white).
2. If internal DIP switch 10 is ON, the wheel will find its reference point then rotate continuously
counter clockwise at 7.5 rpm. If internal DIP switch 10 is then switched OFF without powering
down the wheel will continue rotating until power is recycled. The wheel will then revert to the
status detailed in 1. above.
VEGA
TDMX
TWINKLE
WHEEL
Channel
Func
ti
on
Value
Descrip
ti
on
1
Dimming
0
255
From o
ff
at 0 to brightest at 255
2
Motor control
0
255
From stop at 0 to fastest at 255 (3
4 rpm)
To revert a DMX only light source to normal manual operation of the wheel and the light output,
remove top cover to access the dip switch on the PCB. Set switches 1 to 9 off and switch 10 on, as
detailed below. You must also ensure that the wire links are fitted as detailed below.
REVERTING
A
DMX
LIGHT
SOURCE
TO
MANUAL
OPERATION
MODE
Dip switch 10 must be on
for manual operation
For manual operation to work there
must be wire links fitted to the screw
terminals on the PCB between 10V &
DM and 10V and SPD as detailed,
left.
Switch 10 must be switched
off for DMX operation. Set the
DMX address using switches
1 - 9.
OPERATION
VEGA
USER
GUIDE
8
Summary of Contents for Vega CM
Page 14: ...NOTES VEGA USER GUIDE 14...
Page 15: ...NOTES 15 UFO LIGHTING...
