Instructions for use (rev 011221)
e.ON sinter fast +
UGIN DENTAIRE
12
6.3.
REAL-TIME CURVE (CURRENT CYCLE)
This screen shows the diagram of the current cycle
(time/temperature).
On the screen are displayed two curves: the temperature
setting in the cycle
(blue curve)
and the temperature in real
time
(green curve)
.
The green curve appears with the blue curve superimposed
with the temperature is regulated.
6.4.
INTERFACE PROGRAM EDITOR
A total of 40 programs, composed of 40 temperature/time
pairs, can be edited and saved by selecting a different
program number, each program and pairs of can be edited.
To select a program, press the right or left arrow key: the
numbers of programs is displayed on the screen.
For each program number, the cycle parameters are
displayed as a chart:
-
C represents temperature (°C), and
-
T represents time (minutes).
Each program is two pages: the first page displays the pairs from C01/T01 to C20/T20 and the second page
from C21/T21 to C40/T40. The "
NEXT PAGE
" key switches from the first page to the second page.
6.4.1.
CHANGE SETTINGS
When the program number is displayed on the screen,
“press” the parameter to be modified
. A numeric keypad is
displayed to select the desired value.
Enter the new value using the numeric keypad and press
“
Ok
" to save.
A confirmation message is displayed:
"
Caution: press the Ok key, the data will be saved
".
Press "
Ok
" to confirm or "
Cancel
" to cancel.
When the desired changes of program have been made, press "
SAVE
" key to save the complete program.
After validation, the “
Working interface
”
displayed on the screen.
Summary of Contents for e.ON sinter fast
Page 1: ...INSTRUCTIONS FOR USE Sintering furnace R v 011221...
Page 27: ......
