Instructions for use (rev 011221)
e.ON sinter fast +
UGIN DENTAIRE
17
▪
White clusters can appear on the rods
(heating elements) when different brands or types of zirconia are
used. In this case user must clean muffle and rods with a special zirconia cleaner like Nacera Clean* with
decontamination program No. 40. Avoid use different zirconias (brands or types) in the same cycle.
▪
Always place the support (base + additional raise support) on the platform
during carry out a
decontamination cycle.
ADVICE:
add in a tray with or without a cover white Zirconia smashed in multiple small pieces
(absorption of
pollutants) or a powder specially designed to improve the effectiveness of decontamination (for example,
powder Nacera Clean*).
After running the program, check the condition of the rods:
-
still whitish traces = still contaminated: repeat a decontamination cycle;
-
rods with a grey shiny appearance = ok: furnace ready.
Example of a contaminated rods
Example of rods after decontamination
* Nacera clean is a registered trademark.
Summary of Contents for e.ON sinter fast
Page 1: ...INSTRUCTIONS FOR USE Sintering furnace R v 011221...
Page 27: ......
