Instructions for use (rev 011221)
e.ON sinter fast +
UGIN DENTAIRE
19
6.7.2.
POSITIONING OF ELEMENTS AND TRAY FOR SINTERIZING
6.7.2.1.
TO PERFORM A CONVENTIONAL CYCLE
To perform a conventional cycle, can be use
one or two trays, with cover
.
The capacity is about
40 elements maximum
(depending on the size of the elements, they should not touch
each other).
▪
Put at least one layer of zirconia pearls
into a tray, to prevent the elements from rubbing on the bottom
and sides.
Note: do not exceed two layers of pearls to avoid unrequired mass and therefore thermal inertia.
▪
Place the elements on top of the pearls in the tray
(they should not touch
each other’s
nor the side of
the tray). Capacity about
40 elements maximum.
▪
Two trays can be stacked
.
▪
Always place the cover on the last tray
(only on the last, never between two trays).
▪
Place the tray(s) at the center of support, on the base and additional raise support.
Note: if the zirconia beads are discoloration in yellow colour, they must be replaced.
6.7.2.2.
TO PERFORM A SHORT CYCLE
To perform a short cycle, can be use
one tray only
. The capacity is about 2
0 elements maximum
(depending
on the size of the elements, they should not touch each other).
CAUTION: Follow the recommendations of the manufacturer of the zirconia used to check the
compatibility with the perform of a fast program and the maximum number of elements in
short cycle.
▪
Put at least one layer of zirconia pearls
into a tray, to prevent the elements from rubbing on the bottom
and sides.
Note: do not exceed two layers of pearls to avoid unrequired mass and therefore thermal inertia.
▪
Place the elements on top of the pearls in the tray
(they should not touch each other’s nor the side of
the tray). Capacity about
20 elements maximum xxx
▪
Place the tray at the center of support, on the base and additional raise support.
Summary of Contents for e.ON sinter fast
Page 1: ...INSTRUCTIONS FOR USE Sintering furnace R v 011221...
Page 27: ......
