Instructions for use (rev 011221)
e.ON sinter fast +
UGIN DENTAIRE
4
-
For moving:
-
take hold the furnace by its base:
NEVER LIFT BY UPPER PART OF FURNACE.
-
the furnace must remain in an upright position:
NOT HORIZONTAL POSITION.
-
do not leave any accessories or the support in the heating chamber.
-
Never use the furnace without support.
-
Use only the
support,
tray for sinterizing and cover
provided by UGIN DENTAIRE. Before use,
check it (no dirt or damage).
If damaged: do not use.
-
Respect the positioning of support (base and additional raise support) and the maximum
number of trays to stack
(see chapter 6.7)
: damage equipment risk.
-
The chamber is made up refractory ceramic fibers.
-
Handle carefully.
-
They can release dust: remove with a vacuum cleaner - do not blow or use compressed
air.
-
Use only
genuine spare parts
. The use of non-original spare parts voids any warranty for your
device.
-
Do not introduce stranger objects inside
the unit during the maintenance operations. It is
forbidden to modify the material without authorization.
-
Do not execute different operations of maintenance
from those listed in this manual. Any
operation not included in this manual can involve risks.
-
For any further information concerning installation, maintenance and use, contact the
customer’s service UGIN DENTAIRE.
Summary of Contents for e.ON sinter fast
Page 1: ...INSTRUCTIONS FOR USE Sintering furnace R v 011221...
Page 27: ......
