Instructions for use (rev 011221)
e.ON sinter fast +
UGIN DENTAIRE
9
4.3.
BEFORE START-UP
-
Open the furnace upper cover (unscrew).
-
Remove carefully the cushioning foam pad protecting heating elements.
-
Then visually inspect the heating element
(no damage). Avoid handling.
-
Install exhaust pipe
:
a)
Install the conduit on the intended location (in the centre of heating elements)
b)
Close the furnace cover (screw)
c)
Fix the base of exhaust pipe (screw)
a)
b)
c)
Summary of Contents for e.ON sinter fast
Page 1: ...INSTRUCTIONS FOR USE Sintering furnace R v 011221...
Page 27: ......
