Instructions for use (rev 011221)
e.ON sinter fast +
UGIN DENTAIRE
18
6.7.
POSITIONING THE ELEMENTS AND STARTING THE CYCLE
6.7.1.
POSITIONING OF SUPPORT
▪
To use the furnace,
always place the support on the platform,
including for the decontamination
program.
▪
Use only the original support
e.ON sinter fast +
UGIN DENTAIRE.
▪
Before use,
check if it is in perfect condition
: presence of dirt or damage.
Clean with a vacuum cleaner if necessary
(see chapter 8).
If the support is damaged or cracked, do not use, and replace it.
▪
It is composed of a base and additional raise support.
▪
Always position the two parts (base and additional raise support), whether to position 1 or 2 trays.
Warning: in short cycle, position only 1 tray (see chapter 6.7.2.2).
NUMBER OF TRAY
TO PLACE
SUPPORT TO PLACE
1 tray
base + additional raise support
2 trays
base + additional raise support
IMPORTANT: observe these indications so as not to
exceed the maximum height (risk of damage).
Position a maximum of 2 trays for sinterizing.
Summary of Contents for e.ON sinter fast
Page 1: ...INSTRUCTIONS FOR USE Sintering furnace R v 011221...
Page 27: ......
