Instructions for use (rev 05/18)
e.ON SINTER
UGIN DENTAIRE
28
IMPORTANT:
-
For moving, take hold the furnace by its base. NEVER LIFT BY UPPER PART OF
FURNACE: risk material damage.
-
For transport, the furnace must remain in an upright position: NOT HORIZONTAL
POSITION. Heating material may be damaged in horizontal position due to
vibration/shock.
-
Keep the original packaging to transport the furnace.
-
Wait the complete cooling before packing/transporting.
4.
INSTALLATION
4.1.
Place
Installed in a room aired, ambient temperature (+10°C/+40°C), without humidity (humidity
level less than 85%).
Place the furnace on an easily accessible, level and aired surface. Keep a distance from other
objects around not less than 25 cm, so that the device can work properly under good
ventilation and cooling conditions. Keep it away from heat sources (for example, radiators
and/or other equipment that release heat).
Despite excellent insulation, the furnace provides heat and, in the long term, can discolour
surfaces that are nearest.
Do not shake the furnace, avoid vibrations and shock.
The molybdenum silicon rods are very brittle at room temperature, do not handle them. Avoid
moving the furnace after installation.
Dust, corrosive or explosive gases can damage the body and the insulation.
Its forbidden placing inflammables, toxic, volatile or explosives around the furnace.
4.2.
Before start-up
Open the furnace upper cover (unscrew) and remove carefully the cushioning foam pad
protecting heating elements.
Then visually inspect the heating element (no damage). Avoid handling
Close the furnace cover (screw).
NOTE: For the first time or after a long time without use, need to preheat the muffle furnace
1 hour at 120
℃
follow 2 hours at 300
℃
to eliminate condensation and avoid fractures of the
refractory material.
Summary of Contents for e.ON SINTER
Page 2: ......
