Instructions for use
(rev 150620)
e.ON
UGIN DENTAIRE
15
6.4.2.1.
EXAMPLES OF CALCULATION
▪
Calculation time of second stage (T02)
From the initial and final temperature values of the second stage, calculation of the time stage:
Temperature 1
→
C01 = 900°C
Temperature 2
→
C02 = 1200°C
Temperature
difference:
C02
–
C01 = 1200°C
–
900°C = 300°C
Recommended value of increase rate: less than 10°C/minute
300°C at a rate of 10°C/min
→
300°C / 10°C = 30 min
→
T02 = 30 minutes
▪
Parameters for remain to end temperature (T04)
Parameters temperature/time of end stage to obtain remains to the end temperature of 1520°C for 2 hours:
Temperature 4
→
C04 = 1250°C
Temperature 5
→
C05 = 1250°C
Temperature difference = 0°C:
Temperature remains to 1250°C
Time remains: 2 hours
Time 04:
2 hours x 60 min = 120 min
→
T04 = 120 minutes
Zirconia
SINTERING TEMPERATURES
are given as indicative by disc manufacturer. If necessary,
these one
can be adjusted from -15°C to +15°C
around the final temperature recommended.
We recommend adjusting the temperature/time for special work.
6.5.
PARAMETER SETTING
This interface requires a password to be accessible.
No data may be modified without authorization:
risk of
damages on the furnace or trigger heating untimely.
The modification of the parameters is therefore
reserved
for technicians of customer’s service
UGIN DENTAIRE.
NOTE: even if changes are made to the settings, when saving them, a screen is displayed to insert the
password. When no password has been inserted and validation is done with the "Ok" key, the changes made
are not saved and the original settings remain applicable.
