Instructions for use
(rev 150620)
e.ON
UGIN DENTAIRE
4
C.
INSTRUCTIONS FOR USE
1.
SAFETY INSTRUCTIONS
1.1.
USE
e.ON is a sintering furnace to Zirconium oxide (ZrO
2
) dental prostheses. This furnace has to be
operated only by dental professionals. e.ON
have to use in the conditions and for the uses
described in this manual.
Any other use that will be made of it is considered inappropriate. In this case, the
manufacturer declines all liability and immediately cancels the equipment warranty.
According to the product’s instructions and functionalities,
it is imperative to read carefully the instructions
for use before furnace installation and use.
Retain the manual for future reference.
1.2.
SAFETY INSTRUCTIONS
Pictograms’ meaning used in these instructions for use:
General warning
Electrical hazard
Burn hazard - Hot surface
Observe following safety instructions:
-
During operation and after use,
the furnace head surface, platform, support, tray for
sinterizing and cover may reach high temperatures: do not touch.
-
Wear suitable gloves for handling prosthetic objects, tray for sinterizing and cover and support
-
The unit has to be connected to an
electrical installation in accordance
with the applicable
standard in the country in which it is being used. This installation has to provide
protection
against overcurrent, overload and ground faults.
-
This furnace requires its own power line and has to be connected to a circuit breaker.
-
Connect it directly to the mains socket
. Do not use multiple sockets.
-
Ensure that the
connection cables
are in perfect condition to prevent short circuits.
-
Before any
technical intervention
, the unit has to be switched off (with the breaker) and
disconnected from the mains power supply.
-
Do not spill liquid
on the ventilation openings or inside the furnace.
-
Ensure that the
movement of the tray is not blocked by an object
, this may result in
malfunction of the unit and damage to certain components.
-
The furnace must be placed on a
flat surface
, keeping sufficient clearance around the unit to
ensure proper ventilation.
-
Do not block the ventilation openings
to avoid overheating.
