Instructions for use (rev 031121) - En
PROGRAMIX 50 - 100
UGIN DENTAIRE
5
C.
INSTRUCTIONS FOR USE
1.
SAFETY INSTRUCTIONS
1.1.
USE
Programix 50 and Programix 100 burnout furnaces are intended use to heating the coated cylinders. These
furnaces have to be operated only by dental professionals.
Programix 50 and Programix 100 have to use in the conditions and for the uses described in this manual.
Any other use that will be made of it (such as firing other materials, heating food products, etc.) is considered
inappropriate. In this case, the manufacturer declines all liability and immediately cancels the equipment
warranty.
According to the product’s instructions and
functionalities,
it is imperative to read carefully the manual
before furnace installation and operations
. Retain the manual for future reference.
1.2.
SAFETY INSTRUCTIONS
Pictograms’ meaning used in these instructions for use:
General warning
Electrical hazard
Burn hazard - Hot surface
Observe following safety instructions:
-
During operation and after use,
the furnace surfaces and door may reach high temperatures:
do not touch.
-
Wear suitable gloves
for handling cylinders after heating.
-
The unit has to be connected to an
electrical installation in accordance
with the applicable
standard in the country in which it is being used. This installation has to provide
protection
against overcurrent, overload and ground faults.
-
This furnace requires its own power line and has to be connected to a circuit breaker.
-
Connect it directly to the mains socket
. Do not use multiple sockets.
-
Ensure that the
connection cables
are in perfect condition to prevent short circuits.
-
Before any
technical intervention
, the unit has to be switched off (with the breaker) and
disconnected from the mains power supply.
-
Do not spill liquid
on the ventilation openings or inside the furnace.
-
The furnace must be placed on a
flat surface
, keeping sufficient clearance around the unit to
ensure proper ventilation.
-
Do not block the ventilation openings
to avoid overheating.
-
The heating chamber contains
insulating material
composed of high temperature insulation
wool (alkaline earth silicate), a substance not classified as dangerous according to Regulation
1272/2008/EC (CLP). Handle carefully.
-
Dust can be released: remove with a vacuum cleaner - do not blow or use compressed air.
