5
its power source.
5 OPERATING PROCEDURES
1
Clean and sanitize the unit according to the instructions in
this manual. See chapter 5.3 CLEANING AND SANITIZING
PROCEDURES.
2
Fill the bowls with product to the maximum level mark. Do
not overfill.
The exact quantity of product (expressed as liters and gallons)
is shown by marks on the bowl.
3
In case of products to be diluted with water, potable water,
pour water into bowl first, then add correct quantity of product.
In case of natural squashes, it is advisable to strain them, in
order to prevent pulps from obstructing the faucet outlet.
4
Install the covers and check that they are correctly placed
over the bowls.
5
Set the control switches as shown in chapter
5.1 DESCRIPTION OF CONTROLS.
6
The dispenser must always run with the covers installed to
prevent a possible contamination of the product.
7
Always leave the dispenser on, as the refrigeration stops
automatically when the beverage reaches the dispensing tem-
perature. The mixing devices will continue to turn.
8
To maintain a high standard of flavour, keep refrigeration
and mixing devices on during the night when beverage is in the
bowl.
5. 1 DESCRIPTION OF CONTROLS
The dispenser is equipped with a power switch and each bowl is
operated by a mixing device switch.
Their functions are as follows:
Power switch
Mixing device switch
To operate the dispenser
1
Set power switch to I position.
2
Set mixing device switch(es) to I position.
5. 2 OPERATION HELPFUL HINTS
1
The length of time for cooling down the product is governed
by many variables, such as ambient temperature and beverage
initial temperature.
2
To shorten product cooling down time and increase produc-
tivity, it is advisable to pre-chill the product to be used in the
dispenser.
3
To shorten product cooling down time and increase produc-
tivity, the bowl should be refilled after the product level drops
lower than half and at the start of each day.
4
The dispenser must be able to emit heat.
In case it seems excessive, check that no heating source is
close to the unit and air flow through the slotted panels is not
obstructed by wall or boxes. Allow at least 15 cm (6”) of free
clearance all around the dispenser.
In any case if the product in the bowls is cold the unit is running
properly.
5
How to reset beverage temperature:to reset beverage tem-
perature please apply to a technician.
The proper temperature is preset at the factory.
5. 3 CLEANING AND SANITIZING
PROCEDURES
Cleaning and sanitizing of the dispenser are recommended to
guarantee the conservation of the best product taste and the
highest unit efficiency. This section is a procedural guideline
only and is subject to the requirements of the local Health
Authorities.
Prior to the disassembly and cleaning, the machine must be
emptied of product.
5. 3. 1 DISASSEMBLY
1
Remove cover from the bowl.
2
Remove the empty bowl by lifting first its
front side (faucet
side)
up and off bowl gasket (see figure 1).
figure 1
3
Remove the bowl gasket.
4
Remove the pump impeller from its location.
5
Pinch tube faucet
: push the dispensing handle (1) and
ATTENTION
In case of damages, the power cord must be replaced by
qualified personnel only in order to prevent any shock
hazard.
IMPORTANT
Operate the dispenser with food products only.
0 position
:
Power is turned OFF to all
functions.
I position
:
This position operates the fan
motor and makes the mixing
devices suitable to be turned
on by relevant switches.
0 position
:
OFF.
I position
:
Mixing device runs.
ATTENTION
Before any disassembly and/or cleaning procedure make
sure that the dispenser is disconnected from its power
source by unplugging it or switching off the 2-pole wall
breaker.
