19
screw.(see figure 17)
figure 17
4
In case of noise it needs to unplug the cooler and call for
service.
5
In case of failure unplug the machine, because unexpected
start again would be possible.
6
It needs to fix everything back in the initial position after any
repairmen, like screws and covers.
8. 1 MAINTENANCE (TO BE CARRIED OUT BY
QUALIFIED SERVICE PERSONNEL ONLY)
1
Monthly on MT 1 P model:
remove the dust from the
condenser. To do this unplug the unit.
2
Annually:
remove the panels and clean the inside of the
machine including the base, side panels, condenser, etc.
3
Annually:
Check if the auger bushings are worn out or
ovalized. If they are, replace them with new ones.
4
Never remove the insulating jacket from around the suction
tubing of the evaporator (the copper tubing located on the right
side of gear motor). In case the insulating jacket is missing
replace the entire parts with original spare parts from the
supplier.
5
In order to prevent any damages to the dispenser, all
plastics parts must be lubricated only with grease supplied by
the manufacturer or with another lubricating product suitable for
polycarbonate.
Summary of Contents for MT 1P GL
Page 44: ...02420 00099 R10 7 22N15...
