Linux
Step: "Applications" > "Disks", select the external drive and click "Format Partition"; after
formatting please enter "Mount", then your PC/laptop can read the drive.
V Other Settings
1 Add New Drives
A new hard drive requires RAID mode switching twice, then all hard drives will be formatted. Please
back up all the data in advance.
VI Notes
·
For optimal performance, it is recommended that you use the product on the device with USB 3.0
or above ports.
·
Please put the product in an environment of stable temperature and humidity to avoid direct
sunlight or any liquid.
·
When there is a thunderstorm or an unstable voltage, please power off the product to avoid the
potential damage.
·
Please power off the product before you clean it; clean it with a wet wipe, chemicals or spray
cleaner are not allowed.
·
Do not drop, crush, hit, or throw the product.
·
The product contains small components, please keep out of reach of children.
·
Please do not disassemble or repair this product by yourself. Improper disassembly may lead to
electric shock or other potential danger, please contact UGREEN aftersales.
Warning
If there are less than 5 hard drives in the current RAID mode, then you can add new drive(s).
·
Power off: press and hold the power button (about 3 seconds) until the power indicator goes off.
·
Put the new hard drive in the drive tray and put it into the enclosure.
·
Change DIP switch to PM mode.
·
Press and hold "RESET" and long press the power button (about 3 seconds) to turn it on; after 15
seconds release "RESET", and then the hard drive indicator flashes white.
·
Power off again, and change DIP switch to the original RAID mode.
·
Repeat step 4.
·
After the hard drive is connected and partitioned, then it's successfully added.
Add a new drive
When using RAID 1/3/5/10/Clone modes, you'll have to replace with a brand new hard drive if one
of your disks fails.
·
Press and hold the power button (about 3 seconds) to turn it off.
·
Replace the broken disk with a new one.
Tip: capacity of new hard drive ≥ capacity of broken hard drive.
·
Press and hold the power button (about 3 seconds) to turn it on.
·
When the disk indicator flashes red and white alternately, the new disk starts to restore (back up)
data.
·
When the drive indicator turns solid white, the data recovery (backup) is completed.
2 Replace the Broken Drive
11
12
