Umwelt-Geräte-Technik GmbH
| Eberswalder Str. 58 | D-15374 Müncheberg | Tel.: +49 (0) 33 43 2 - 89 575 |
2.
General information
2.1.
Structure and basic function
The basic construction is the same for all UMP-1 variants (Fig. 1). The probe is waterproof
and can be completely buried for a depth or horizontal installation. It is made of plastic or
stainless steel, while the measuring rods (antennas) are always made of stainless steel.
Regular maintenance is not necessary. On request, the measuring rods can also be produced
in other lengths. In this case, the measuring frequency also changes.
Cable connection
(optional)
Housing
(plastic or stainless
steel depending on
design)
Ø = 40 mm
Temp. sensor
Thread for antenna
Pin (bare stainless
steel)
Ø = 3 mm
