Turn off your dispenser and unplug it. Make sure that your water dispenser is not fed power.
Turn on the valves and drain 1 lt. of water.
Remove the bottle from your dispenser.
Place a bowl under discharge outputs and open the discharge plugs to completely drain the water. Wait until the whole
water is discharged.
You can use your water dispenser after placing back the discharge plug.
Cleaning, disinfection of your water dispenser
and cleaning the mineral wastes
Cleaning of your water dispenser
Disinfect your water dispenser using Uğur Water Dispenser Cleaning and Disinfectant Agents you will provide from
Uğur Authorized Services according to the instructions for use of Uğur Water Dispenser Cleaning and Disinfectant
Agent. Rinse your water dispenser with water as described above. You may perform this cleaning procedure once in
every three months.
Prepare a solution by mixing 200 gr. citric acids with 4 lt. of water and inject this solution to your appliance. Turn on the
hot water button and wait for 10 minutes for the water to heat. Drain off the solution 30 minutes later. Rinse your
appliance with water for 2 or 3 times. You may perform this cleaning procedure once in every six months.
Warning
• The temperature of the water flowing from the hot water valve of your dispenser is approximately 90°C. Avoid direct
contact with hot water. This may cause burns and injuries.
• Never use organic liquids to clean your water dispenser. Avoid splashing water inside your water dispenser. This may
result in the malfunctioning of your appliance or it may become unserviceable.
Disinfecting your water dispenser
Cleaning the mineral wastes from your water dispenser
8
Things to do when leaving for a vacation
•
If you will not use your water dispenser for a long period of time, turn off the power button and unplug its power cable.
Drain off the remaining water inside your water dispenser from the discharge holes.
