DAISY
16
2.4
Programming
mode
The programming mode can be used to program (configure) locomotive
or turnout decoders and for changing configuration parameters of the
DAISY throttle. Decoder programming is only supported if the DAISY
throttle is connected to the “DAISY” connector of a Power2.
Important
Decoder programming commands will be repeated by
all
boosters con-
nected to the DAISY-System. Therefore, it is important that only the
locomotive(s) which you wish to program/configure should be sitting on
the rails. Other locomotives must be temporarily removed from the
layout.
This is how to proceed:
•
Press the [Prog] key. The display indicates:
ProG
•
Release the [Prog] key. The display indicates the programming/confi-
guration option used last:
C
CV (direct) programming
r
Register programming
S
Special Options edit
The remaining 3 digits show the number of the CV, Register or
Special Option which has been selected last.
•
Press the [function] key as required for the desired programming/con-
figuration option to be shown
•
Rotate the encoder to select the desired CV, Register or Special
Option number
•
Press the [Prog] key to select that particular CV, Register or Special
Option
•
In case of a CV or Register, the display will indicate either 0 (zero) or
the value which has been written to a CV or Register last. Please note
that this is not necessarily the current value of the selected CV or
Register. In case of a Special Option, the display will indicate the
current value of the selected Special Option.
•
Rotate the encoder to select the desired CV, Register or Special
Option value
TIP
The value can be displayed in hexadecimal format by pressing the
[function] key. It will revert to decimal format as soon as that key is
released.
•
Start CV, Register or SO programming by pressing the [Prog] key.
•
The ongoing of CV and Register programming is indicated by “walking
dashes” on the display
•
You can leave programming mode at any time by pressing either the
[Locomotive] or the [Turnout] key
Summary of Contents for DAISY
Page 1: ......
Page 25: ...DAISY 25 Power 2...