Service manual
Compact electronic knob cylinder
12
When cylinders are ordered separately, the internal components of the cylinder may fall out when remov-
ing the transport protection, as these are held securely in the cylinder only after the electronic knob is in-
serted. Note the following when inserting the internal components:
1.
The knob shaft (2) need not be removed for the assembly.
2.
The locking cam (8) is positioned in the cylinder opening when assembling the internal parts.
The carrier knobs inside the locking cam have to point in the direction of the knob shaft (2).
3.
The number and length of the filler parts (5) depends on the cylinder length. They are inserted in-
to the cylinder such that the two carrier lugs point towards the electronic knob (7).
4.
The coupling carrier (6) has two slots for the two carrier lugs of the filler parts (5) or the knob
shaft (2). It has to point towards the knob shaft (2).
The side of the coupling carrier (6), which points in the direction of the electronic knob (7) has
four smaller slots.
Illustration Standard cylinder
Illustration Half-cylinder
Then insert the new electronic knob into the cylinder as far as it goes and turn it slowly vis-a-vis the lock-
ing cam until all the parts mutually engage and the electronic knob is completely inside the cylinder. Only
then can the electronic knob be fixed using the snap ring.
This procedure becomes easy if the product is engaged when interlocking and turning.