Service manual
Compact electronic knob cylinder
8
4
Rotation of the cylinder
4.1
Relates to the following variants
CX6162
CX2162
4.2
Necessity of the measure
When ordering, the external and internal dimensions of the fixing screw were mixed up, the cylinder has
to be rotated.
The cylinder dimensions have to be changed. Other parts are required here which will be included when
the cylinder is re-ordered.
4.3
Procedure
If the cylinder needs to be rotated, both the electronic knob and the mechanical knob have to be separated
from the cylinder. This should only be done by trained personnel.
Remove the snap ring between the locking cam and the mechanical knob.
CAUTION
Parts falling out of the cylinder
When pulling out the mechanical knob make sure that the
parts do not fall out of the cylinder.
