CX2172/4
T
ABLE OF CONTENTS
27
The short plate is mostly used in steel doors, where the two standardised holes
for a short plate fitting are often already present. The holes have to be drilled
in the door subsequently if required, as described below.
Insert the square pin of the electronic door handle into the square nut of the
lock.
Place the drilling template on the square pin, align horizontally and centre
punch the hole markings.
Remove the square pin again.
Drill holes of diameter 8 - 8.5 mm at the marked positions. Do not drill into
or through the lock casing.
Insert the square pin of the electronic door handle once again into the square
nut of the lock. If necessary, place the adapter sleeve supplied on the square
pin.
Short plate
