CX2172/4
T
ABLE OF CONTENTS
38
Unscrew the screw on the inside of the door handle till the stop, such that the
gripping sleeve cannot be removed.
When managing the locking system using the Keyng software, check the door
handle time, using Keyng CX2530 and adjust it if required.
7.2.2 Replace the sealing rings (for the outdoor version of the doors)
The outdoor version of the electronic door handle is provided with two seals
(large sealing ring and grub screw with sealing ring) which prevent water from
entering. To further ensure the leak-tightness of the electronic door handle, both
the seals have to be replaced every time the handle is opened. These are
available as a set from your dealer.
Precondition: Gripping sleeve is removed (see chapter 7.2.1Replacing the
battery, Page 37)
7.2.2.1
Replace the large sealing ring
CAUTION
Damage to the sealing ring caused by improper handling
Do not use any sharp objects and do not stretch the sealing
ring more than what is required for mounting.
Precondition: Gripping sleeve is removed (see chapter 7.2.1Replacing the battery
, Page 37)
To remove the sealing ring, hold down the sealing ring on one side with the
thumb and slide the finger nail of the middle finger on the opposite side. The
sealing ring can now be grasped by the index finger.
Insert a new sealing ring.
7.2.2.2
Replace the sealing ring with grub screw
Unscrew the screw on the inside of the door handle in the direction of "1"
completely and replace it with the new grub screw from the set. Insert the
screw again until it stops in the direction of "2".
