CX2192
C
OMMISSIONING
12
5
Commissioning
Basically, there are two ways to manage a Clex private locking system and
thereby programming the CX2192 cabinet lock:
Management as programming / clearing system
Management using the CX2530 Keyng software and wireless stick /
programming station
5.1
Programming the service key
In its original condition (delivery status), the service key is not yet programmed
into the cabinet lock.
Wake the electronic cabinet lock by pressing the button. Upon success, the
electronic locking cylinder responds with three long audible signals.
Within the next 15 seconds, the service key can now be programmed by
holding it in front of the electronic cabinet lock. Once the service key has
been programmed successfully, the cabinet lock indicates this with two short
and one long audible signal.
After programming, the cabinet lock enters the programming mode when the
service key is held up.
5.2
Management as programming / clearing system
5.2.1
Programming the key
Hold the service key in front of the reading unit of the cabinet lock. The
cabinet lock enters the programming mode.
Hold the key to be programmed in front of the reading unit until two short
audible signals indicate the success.
Optionally, program additional keys as described in the previous step.
Hold the service key in front of the reading unit or wait 15 seconds to exit the
programming mode.
To create a key with toggle authorisation, hold the key for 3 seconds in front of
the reading unit during the programming process until the success is indicated by
3 short audible signals.
5.2.2
Delete key
Hold the service key in front of the reading unit of the cabinet lock. The
cabinet lock enters the programming mode.
Hold the key to be deleted in front of the reading unit until two long audible
signals indicate success.
Optionally, delete additional keys as described in the previous step.
Hold the service key in front of the reading unit or wait 15 seconds to exit the
programming mode.
5.2.3
Delete all keys
Hold the service key in front of the reading unit of the cabinet lock. The
cabinet lock enters the programming mode.
Hold up the service key until the cabinet lock exits the programming mode.
