UHP SCPC MODEM
USER MANUAL, v3.2
© ROMANTIS 2015
44
www.uhp.net
8.2
Configuration of Memory Banks
UHP has two configuration banks (current settings). Each bank contains a full router configuration with 8 profiles,
routing and stations information. By default the configuration is loaded from Bank 0. The equipment allows
changing the boot loader settings specifying the number of configuration memory bank.
To select the configuration bank to be used when booting the router follow Advanced -> System -> Flash / Boot
and specify the configuration bank number Boot control section, Main boot -> Config bank setting (see Figure 47).
See Figure below (see Figure 48) for the UHP router configuration loading and storage settings.
Figure 48 Loading and storage of UHP router configuration
SW Version
–
SW version for which the configuration is stored;
Sequence
–
Increases by 1 after each save;
Save Time
–
Time of configuration saving;
Bank
–
Memory bank for configuration storage or loading;
File
–
File name for SW saving or loading applying TFTP-server. Find TFTP-server
configuration settings in Advanced –> IP protocols –> TFTP section.
This section is accessed by going to Advanced -> System -> Save/Load in Control and statistics tree.
Flash Section.
Clicking the Save button will store the current device configuration in the selected configuration
bank. Clicking the Load button will load the configuration stored in the selected bank as the active configuration.
TFTP Section.
To upload the current router configuration to the TFTP-server as a binary file, enter the name of the
binary file and click Load. To download a configuration from the TFTP-server to the router as an active
configuration click Save (see Configuration Using Settings File).
8.3
Installing New SW
The downloaded SW images can be stored in the UHP in three memory banks. When loading a new SW image,
choose a memory bank number and indicate the bank to be used when booting the router. The loaded SW image
will be used after the device is restarted.
UHP-router SW is installed in one of two ways:
1.
Applying router WEB-interface;
2.
Applying a console connection to the router and TFTP-server.
8.3.1
SW Installation via WEB-Interface
To download the new SW:
