9
FCC Warning
FCC ID: 2A4H6HBK-A01
This device complies with part 15 of the FCC Rules. Operation is subject to the foll-
owing two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation. Any changes or modifications not expressly approved
by the party responsible for compliance could void the user's authority to operate
the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are desi-
gned to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:-- Reorient or relocate the receiving antenna.-- In-
crease the separation between the equipment and receiver.-- Connect the equipm-
entinto an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. To maintain
compliance
with FCC's RF Exposure guidelines,
This equipment should be installed
and operated with minimum distance between 20cm the radiator your body:
Use only the supplied antenna.
EN
