installation
You only need a pipe wrench in order to loosen the Perlator from your water tap
and mount the supplied Perlator adapter.
Unscrew the Perlator from the water tap.
Screw on the thread adapter
or
the changeover valve (optional) with the
black sealing ring facing up.
Screw the rotary adapter onto the thread adapter
or
the changeover valve
(optional).
Remove the red protective cap from the water filter.
Screw the water filter to the rotary adapter.
Set the rotatable adjustable discharge to the desired position.
the ujeta water filter is now ready to use. the manufacturer accepts no liability
for damages caused by improper handling.
imPortant
Before using for the first time, allow at least 2-3 litres of cold
water to flow through the system. Should you not have used the water filter
for a number of hours, please allow the water that might still be held in the
filter to drain off (approximately 1 litre).
note
The water filter device must not be operated with hot water (above 25
degrees) or downstream of an unpressurised boiler. The water filter must be
protected from frost.
1
2
3
4
5
6
ga_ht_print_Layout 1 22.10.17 17:31 Seite 13
Summary of Contents for Home + Travel
