Assembly
19
Fig 32
Fig 33
Scale
Locking knob
K
Step 4 Locate the two lock Hex nuts (g) and slide each one
into the machined recess in the fixing brackets (K), see fig
33.
g
Step 5 Locate the fence assembly (H), ‘T’ bolts (d) and flat
washers (i). Insert six ‘T’ bolts into the pre-drilled holes in
the fence (H), place a washer (i) on each ‘T’ bolt and screw
on the locking knobs (b), see figs 34-35.
Fig 34-35
b
i
H
d
Step 6 Locate the two adjustable wood faces (M), lineup
the ‘T’ bolts (d) with the ‘T’ slots in the wood face (M) and
slide on the wood face, lightly tighten, see fig 36. Repeat
for the other side.
Fig 36
d
M
Step 7 Locate the two locking handle knobs (a) and flat
washers (i). Line up the machined slots in the fence (H)
with the two locking Hex nuts (g) in the fixing bracket (K).
Place a washer (i) over the thread on the locking handle
knobs (a), screw the handle knobs through the fence base
clamping the fence assembly to the table top, see fig 37.
Fig 37
a
i
H
Machined slot
Continues Over...
