9) Master Reset
CALIBRATING THE SEGBOARD
If the Segboard is making is sounding a continuous alarm or Red error
light is showing, then its sensors may need be tuned or reset. You need
to calibrate the device, which takes about 60 seconds. Follow these steps
to resolve the problem.
1.
Make sure you do not press down on the foot pads during
calibration. This will cause permanent damage to the sensor
associated with the foot pad, and the part will need to be replaced.
Before calibration, press up and down on the foot pads to make
sure they are in the fully off position, which is fully horizontal and
parallel to the ground.
2.
Perform calibration on ground that is as flat as possible. No hills, no
sloping driveways, no inclines. The best place to calibrate the
Segboard is indoors on a completely flat surface, but any flat ground
will do.
3.
Align the two halves of the Segboard with each other. They should be
perfectly aligned and not twisted away from one another in any way.
4.
Keep the halves aligned, make sure the Segboard is parallel with the
ground. The footpads should be flat and parallel with the ground.
5.
Push and hold the power button for about 5 seconds. You will first
