UKIAH TAILGATER, Manual

14

[Figure 4] - Turn gas control to “OFF”. 

[Figure 5] - Connect supplied regulator 

and do not over-tighten. 

[Figure 6] - Attach quick-connect end of 

regulator to the unit. 

REGULATOR CONNECTIONS:

Your Ukiah Co gas fire pit is equipped with a specialized pressure 
regulator, which is a device to control and maintain uniform gas 
pressure as gas is released from the LP cylinder.  This pressure 
regulator is designed for vapor withdrawal.

WARNING

: Use only the original specially designed regulator 

supplied with your unit.  Using another regulator may be dangerous.

 WARNING:

 Use tanks that are marked “Propane Fuel” only.

WARNING

: Read carefully all instructions contained on the 

information plate attached to the fire pit. 

WARNING

: Do not transport your fire pit with LP Tank connected.  

1.  Place the fire pit in the desired location. Make sure that it is placed 
outdoors in a well-ventilated area away from any flammable structures, 
awnings, vegetation, etc.  

2.  Place your 20lb LP tank in a location that is not in a walkway or 
where it can be easily knocked over. Always use the provided tank 
stand (see page 7 for details). Maintain 60 inches between the unit 
and tank. For safest operation use a commonly-available LP tank 
holder.

3.  Make sure the unit gas control knob is turned to “OFF” by pushing 
it in and turning it clockwise to the off position. [Figure 4]

4.  Make sure the propane cylinder valve is turned off by turning valve 
clockwise. 

5.  While holding carrying handle closest to propane cylinder, connect 
regulator to propane cylinder and turn clockwise until snug (DO NOT 
OVER-TIGHTEN). Use only supplied regulator included with your unit. 
[Figure 5] 

6.  Attach quick-connect on opposite end of regulator hose to your 
unit. [Figure 6]

 WARNING:

 Do not over-tighten or use a wrench to tighten the 

regulator connection.  Over-tightening could damage the regulator 
coupling and cause a leak.

LP TANK REMOVAL:

When the LP tank needs to be replaced, follow these instructions to 
remove it.
1.  Make sure gas control knob is turned “OFF” by pushing it in and 
turning it clockwise to the off position.
2.  While holding carrying handle closest to propane cylinder with one 
hand, unscrew propane cylinder from regulator. 

SETUP INSTRUCTIONS