discharging. When the battery is empty, the machine
is switched off by means of a protective circuit: The
tool holder no longer rotates.
In a warm environment or after heavy use, the battery
pack may become too hot to permit charging. Allow
time for the battery to cool down before recharging.
3. TO REMOVE OR INSTALL BATTERY PACK
(Fig. 5)
!
Fig.5
●
Always release the On/Off switch before
insertion or removal of the battery pack.
●
To remove the battery pack, withdraw it from the
tool while pulling the Battery Release Button
(10) down.
●
To insert the battery pack, groove along the
handle and insert in the full position, until the
Battery Release Button (10) bounce back to
normal position again.
Do not use force when inserting the battery
pack. If the cartridge does not slide in easily, it is
not being inserted correctly.
4. STARTING/STOPPING (Fig. 6)
!
Fig.6
press trigger
③
until the stop, This will turn blower
on. Then push trigger lockout
④
and release the
trigger, In this way, the trigger is locked. Continue to
press the trigger, And then release the trigger, this
turn blower off.
5.
SPEED REGULATION(Fig. 7)
!
Fig.7
The blower is stepless speed regulation. (6)
for the
high speed,
The speed switch spin down to (1) as the
low speed.
6. USING THE BLOWER
The blower is intended for residential use only.
Use the blower outdoors to move debris from hard
surfaces. This blower is not designed to clear leaves
from large grassy areas, or move wet, heavy debris.
USER TIPS
- Hold the blow tube approx 7” above the ground
when operating the tool. Use a sweeping motion from
side to side. Advance slowly keeping the accumulated
debris/leaves in front of you.