Ulthera, Inc.
Page
33
5.3.
Electrical Requirements
The Ulthera System has an international power supply and may be used with
100-240 VAC, 50-60 Hz power systems. See Section 4.1 Electrical and Fire
Safety for additional information.
5.4.
Connecting Components
5.4.1.
Connecting the Handpiece
The handpiece connector receptacle is located on the left side of the
control unit’s front panel as shown in Figure 5.1. To attach the handpiece
connector, align it with the white dot facing up and push it into the
receptacle. It will latch when seated properly.
Figure 5.1
Handpiece Connector Receptacle.
To disconnect the handpiece, twist the coupling ring on the connector
counterclockwise while pulling outwards.
5.4.2.
Identifying and Connecting Transducers
Transducers are identified by the label on the top of the transducer which
includes the name of the transducer (Ulthera DeepSEE), treatment frequency
and treatment depth (DS X-X), a unique serial number, a part number, and
date of manufacture.
The Treatment Guidelines on the control unit interface will display the
recommended transducer to utilize based on the anatomical area you have
selected to treat.
Summary of Contents for DeepSEE DS 10 -1.5
