2/4
【
Operation
】：
1.
The mode switch:
(1).
Press the [MODE/SET] key to switch cycle of step, distance, calories,
exercise time, MVPA mode.
(2).
In memory mode, you can also use the [MODE/SET] key to switch cycle of
each function mode.
2.
Memory switch:
(1).
In addition to Setting mode, the mode of a variety of functions can be
switched to information screen of seven days memory.
(2).
Press [MEM/
△
] key sequence to switch -1 → -2 → -3 → -4 → -5 → -6 →
-7 → Total → Today → -1 → ...
3.
Setting mode: Press and hold [MODE/SET] key to enter following setting modes.
(1).
In setting mode, press [MODE/SET] key to switch the parameters to be set.
(2).
Press [MEM/
△
] key, you can increase the parameter value. Press and hold
this key, you can quickly increase the parameter value.
(3).
Press [RST/
▽
] key, you can decrease the parameter value. Press and hold
this key, you can quickly decrease the parameter value.
(4).
As setting is completed, press the [MODE/SET] key to exit from the setting
mode or wait for one minute the pedometer will automatically exit from the
setting mode.
Step Mode: Can be sequentially set the hours, minutes, weeks, 12/24
hour format.
Distance Mode:
Can set the stride.
Calorie Mode:
Can set the body weight.
MVPA Mode:
Sequentially set the SPM and the time threshold (standard).
Default standard value : SPM = 110 Step/M , time = 0 minutes
4.
Inch / Metric switch:
(1).
Switch memory mode to TOTAL, then press and hold [
MEM/
△
] and [
RST/
▽
]
key. As a full screen flashing shown
, it means that the switch is successful, you
can release the key.
(2).
After Inch / Metric switched, all the data stored will be cleared.
5.
Data clear: As the [RST/
▽
] key pressed and held, all that data Today including
steps, distance, calories and etc will be cleared.
